The following rules and procedures shall be complied with in dealing with the use of equipment:
1. Gears, sprockets, chains, drive, head, tail and take-up pulleys, flywheels, couplings, shafts, saw blades, fan inlets and similar exposed moving machine parts which may cause injury to persons shall be guarded;
2. Overhead belts shall be guarded if the whipping action from a broken belt would be hazardous to persons below;
3. Guards at conveyor drive, head and tail pulleys shall be sufficient to prevent a person from reaching behind the guard and becoming caught between the belt and the pulley;
4. Protruding set screws on revolving parts shall be guarded;
5. Except when testing the machinery, guards shall be securely in place while machinery is being operated;
6. Guards shall be sufficiently strong and maintained to provide the required protection;
7. Stationary grinding machines other than special bit grinders shall be equipped with:
a. peripheral hoods, less than ninety-degree throat openings, capable of withstanding the force of a bursting wheel,
b. adjustable tool rests set as close as practical to the wheel, and
c. safety washers;
8. Face shields or goggles, in good condition, shall be worn when operating a grinding wheel;
9. Hand-held power tools, other than rock drills, shall be equipped with controls requiring constant hand or finger pressure to operate the tools or shall be equipped with friction or other equivalent safety devices;
10. Guards or shields shall be provided in areas where flying or falling materials present a hazard;
11. Vehicles such as forklifts, trucks, front-end loaders and bulldozers shall be provided with roll bar protection when necessary to protect the operator;
12. Forklifts, trucks, front-end loaders and bulldozers shall be provided with substantial canopies when necessary to protect the operator against falling material;
13. Unsafe equipment or machinery shall be removed from service immediately;
14. Machinery and equipment shall be operated only by authorized and experienced persons;
15. Repairs or maintenance shall not be performed on machinery until the power is off and the machinery is blocked against motion, except when machinery motion is necessary to make adjustments or when non-energized components of large machinery can be safely repaired while the machine is operating;
16. Men shall not work on mobile equipment in a raised position until it has been blocked in place securely. This does not preclude the use of equipment specifically designed, such as elevated mobile work platforms;
17. Drive belts shall not be shifted while in motion unless the machines are equipped with mechanical shifters;
18. Belts, chains, and/or ropes shall not be guided onto power-driven moving equipment especially designed for hand feeding;
19. Pulleys or conveyors shall not be cleaned manually while the conveyor is in motion;
20. Belt dressing shall not be applied manually while belts are in motion unless an aerosol-type dressing is used; and
21. Machinery shall not be lubricated while in motion when a hazard exists unless equipped with extended fittings or cups.
Laws 1978, c. 148, § 16, emerg. eff. April 7, 1978.
Structure Oklahoma Statutes
§45-1.2. Violation of Board order - Notice - Hearing - Misdemeanor - Injunction - Action.
§45-1.3. Hearings - Hearing officer - Judicial review.
§45-1.4. Inspection of mines - Mining records.
§45-1.5. Rules and regulations.
§45-1a. Powers and duties of Commission.
§45-1b. Chief Mine Inspector - Director.
§45-1c. Powers and duties of Director.
§45-1d. Additional powers and duties of Director.
§45-1f. Oklahoma Miner Training Institute - Duties.
§45-1g. Department of Environmental Quality - Regulation of certain mining activities.
§45-2. Certificates of competency - Violations - Examinations - Qualification.
§45-3. Chief Mine Inspector - Assistant Mine Inpectors.
§45-3.1. Director of Department of Mines.
§45-5. Certificates - Contents - Fees.
§45-31. Chief Mine Inspector - Annual report to Governor.
§45-32. Examinations of mines.
§45-33. Journal of inspections - Official communications - Equipment and material.
§45-34. Office - Property of state.
§45-37. Withdrawal of person's from dangerous mine - Violations - Penalties.
§45-40. Obstruction of inspectors - Penalty.
§45-41. Disputes between operators and miners.
§45-44. Special counsel in certain proceedings involving Attorney General.
§45-45. Study of mining laws - Recommendations and proposed legislation.
§45-46. Market study and sulfur emissions standards study - Recommendations.
§45-47. Funding of activities.
§45-48. Borrow pits - Jurisdiction.
§45-412. Mine inspectors - Duties.
§45-413. Mine inspector to require compliance with act.
§45-414. Examination and inspection of mines - Time and manner.
§45-415. Dangerous conditions - Additional shafts.
§45-416. Health of employees - Underground excavations - Ventilation.
§45-417. Dust - Water lines - Sprinkling attachments.
§45-418. Loss of life or injury - Duty of operator and inspector.
§45-419. Shaft hoisting engineers - Age and experience - Duties - Loading and unloading.
§45-421. Shaft collars - Cribbing and timbering - Pipes and air lines.
§45-424. Explosives - Storage, transportation, handling and use.
§45-434. Orders of Mining Inspector - Review.
§45-435. Neglect or failure to perform requirements - Penalty.
§45-436. Open mine shafts - Covering - Approval - Penalties.
§45-437. Interference with protective covering devices - Penalties.
§45-442. Use of engines not meeting standards prohibited.
§45-477. May stop mining, when.
§45-478. Penalty for obstruction.
§45-502. Maps to be corrected every six months.
§45-503. Mine inspectors to be furnished copies of maps.
§45-504. Penalty for failure to furnish map copies.
§45-505. Conduct of developments.
§45-506. Ventilation - Construction of air and hoisting shafts.
§45-507. Openings to be separated by natural strata.
§45-508. Shaft not more than seventy-five feet deep.
§45-509. Hoisting machinery in shaft over seventy-five feet deep.
§45-510. Angle of traveled slope.
§45-511. Inspection of hoisting equipment and stairs.
§45-512. Safety equipment for shafts.
§45-513. Quality and testing of chains.
§45-514. Number of persons lowered or hoisted at one time.
§45-515. Inspection - Guard railings.
§45-518. Ventilating fans and doors.
§45-519. Mines to be kept free from gas.
§45-522. Electric wires to be insulated.
§45-523. Machines to be shielded - Electric pumps.
§45-524. Use of oil and grease.
§45-525. Precautions in dangerous workings.
§45-527. Precautions against dust or explosive matter.
§45-528.1. Water on cutter bars and rock drills - Use required.
§45-528.2. Violations by mine owners, operators, etc.
§45-528.3. Violations by miners and persons operating drills or machines.
§45-529. Workers' compensation coverage - Penalties - Exceptions.
§45-580. Punishment for offense.
§45-603. Cheating by molesting check numbers on cars.
§45-604. Punishment for offense.
§45-614. Definition of special terms.
§45-615. Violations of statute as misdemeanors - Civil liability.
§45-616. Construction of sewage or drainage facilities into operating or abandoned mine - Penalty.
§45-722. Declaration of policy.
§45-724. Permits - Limited Use Permits - Applications - Bond - Permit or bond release applications.
§45-725. Procedure for reclaiming land.
§45-726. Refuse disposal areas.
§45-729. Violations - Notice - Hearing - Enforcement - Informing of surface owners.
§45-732. Powers and duties of Department.
§45-734. Chief Mine Inspector.
§45-735. Sand and gravel - Inspections - Penalties.
§45-737. Governmental agencies to conform.
§45-740.2. Legislative findings - Purpose.
§45-740.3. Powers and duties of Commission.
§45-740.4. Participation in Abandoned Mine Reclamation Fund.
§45-745.2. Term of permit - Fee - Transferability.
§45-745.3. Termination of permit - Extension.
§45-745.4. Renewal of permit - Application - Burden of proof - Term.
§45-745.8. Criteria for approval of permit or revision application.
§45-745.10. Revision of permit.
§45-745.13. Objections to application for permit - Informal conference - Hearings.
§45-745.14. Findings - Notice to applicant - Hearing on findings.
§45-745.16.1. Small operator assistance program.
§45-745.18. Impoundments of water on mining sites.
§45-745.19. Augering operations.
§45-745.20. Disposal of wastes.
§45-745.21. Surface mining near active and abandoned underground mines.
§45-745.22. Reclamation efforts - Variances.
§45-747. Backfilling, compacting, and grading.
§45-748. Conditions where backfilling, compacting, and grading are necessary.
§45-749. Restoring excess overburden, spoils and waste materials.
§45-750. Removal and restoration of topsoil.
§45-751. Disturbances to hydrologic balance.
§45-753. Explosives - Rules and regulations.
§45-754. Reestablishment of native flora - Length of liability.
§45-754.1. Spoil material - Placement.
§45-754.2. Performance standards.
§45-755. Steep slope surface mining - Performance standards - Exemptions.
§45-757. Prime farmland - Soil restoration - Exemptions.
§45-760. Mine operators - Duties.
§45-760.1. Suspension of underground mining in certain areas.
§45-760.2. Application of act to surface operations - Modifications.
§45-761. Licenses and permits - Display - Inspection.
§45-765. Data collection and analysis.
§45-766. Right of entry - Inspections - Signs - Violations - Public inspection of records, etc.
§45-767. Conflicts of interest - Violations.
§45-768. Reports of violations of act - Informal review - Inspection procedure.
§45-770. Release of performance bond or deposit - Application.
§45-771. Release of performance bond or deposit - Inspection and evaluation of reclamation work.
§45-774. Civil actions to compel compliance with act - Exceptions.
§45-775. Inspection of violations.
§45-777. Abatement of violation - Notice - Hearing - Cessation orders.
§45-778. Suspension or revocation of permit.
§45-779. Notices and orders - Requirements.
§45-783. Limitations on surface coal mining operations.
§45-784. Cooperative agreements with federal government.
§45-787. Appeal of order or other action.
§45-788. Enforcement or protection of interest in water resources - Replacement of water supply.
§45-789. Rules and regulations.
§45-790. Unconstitutionality of Surface Mining Control and Reclamation Act of 1977 (P.L. 95-87).
§45-791. Federal rules and regulations - Compliance - Reimbursement for costs.
§45-791.1. Alternative reclamation practices.
§45-792. Assistance of state agencies.
§45-793. Federally inspected reclamation activities.
§45-852. Governor as ex officio member.
§45-853. Supplementary agreements - Legislative appropriation.
§45-902. Certificate of competency - Violations - Examinations - First-aid certificates.
§45-903. Certification of applicants - Fees.
§45-904. Records - Rights and duties of certificate holders.
§45-905. Revocation of certificates - Notice.
§45-907. Inspection and examination of active strip and surface mines - Reports - Recommendations.
§45-908. Employment of certified strip pit mine foreman.
§45-909. Foreman - Duties and responsibilities.
§45-910. Proper ground control - Rules and procedures.
§45-911. Explosives - Rules and procedures for storage.
§45-912. Drilling for blasting - Rules and procedures.
§45-913. Loading, hauling or dumping - Rules and procedures.
§45-914. Travelways - Rules and procedures.
§45-915. Electricity - Rules and procedures.
§45-916. Equipment - Rules and procedures.
§45-917. Personal protection - Rules and procedures.
§45-918. Augering - Rules and procedures.
§45-919. General rules and procedures.
§45-931. Operator's fee - Disposition - Production report and forms.
§45-932. Delinquent reports and fees - Penalty - Time extension.
§45-933. Failure to report - Ascertainment of coal mined - Determination of fees - Penalty.
§45-934. Lien for fees - Perfecting - Notice - Indexing - Release
§45-935. Collection of delinquent fees.
§45-938. Department of Mines Revolving Fund.
§45-938.1. Oklahoma Miner Training Institute Revolving Fund.
§45-939. Coal-fired electric generating plants - Burning Oklahoma coal.
§45-939.1. Cost increases to consumers and impairment of certain contracts prohibited.